The 304 stainless steel mop pool faucet for home user often encounters the problem of dripping water. If the joint is not tightened, it will cause water leakage during use, and the joint will become loose. Use the maintenance tool to tighten the joint, then it will be solved. If the water inlet pipe is broken If so, the water inlet pipe needs to be replaced.

How toreplace 304 stainless steel mop pool faucet for home user?
For the connection between the water inlet pipe and the faucet, select a 304 stainless steel mop pool faucet for home user with a suitable port before installation. The front end should be larger than that, and the port should be flat to prevent water leakage. If the port is not flat, it can be smoothed with a file.
1. Press the locking rod down on the slider, and the water inlet pipe becomes the two parts below the joint and the locking rod.
2. Remove the marking plate on the water inlet pipe joint.
3. There are 4 nuts on the joint. After loosening the nuts, put the water inlet pipe joint on the 304 stainless steel mop pool faucet for home user, so that the inner sealing ring of the joint is in close contact with the faucet, otherwise there will be water leakage problems. If it cannot be fitted, take out the inner bushing of the joint and then put it back on.
4. Tighten the nut on the connector.
5. Press the locking lever down on the slider to connect the water inlet pipe to the joint and put down the slider.
Precautions:
1. Open the 304 stainless steel mop pool faucet for home user, and check whether there is water leakage between the water inlet pipe joint and the faucet interface.
2. Do not forcefully bend the water inlet pipe to avoid damage to the pipe.
3. The outlet end face of the 304 stainless steel mop pool faucet for home user should be flat. If it is not flat, it needs to be flattened with a file to avoid water leakage.
4. Never remove the absorbent pad. Be sure to check whether the absorbent pad is damaged before each use.